Industrial Machinery

WITT to Present Precision Gas Mixing and Safety Products at FABTECH 2026

The gas-controls specialist will use Booth S46114 to present mixing, pressure-regulation and backflow-protection equipment.

Priya RamanOctober 25, 20265 min read4 views

A conceptual brushed-steel gas-control cabinet with a touchscreen, valves, regulators and a buffer tank, set near industrial gas cylinders.

WITT Gas Controls plans to exhibit at FABTECH 2026, scheduled for Oct. 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. The company will welcome visitors to Booth S46114 to discuss its MEM+ gas mixers, dome pressure regulators and gas safety valves.

WITT describes itself as a global provider of gas safety, control and analysis solutions. At the show, it intends to focus on equipment for precise mixing, stable pressure and system protection.

The MEM+ series mixes two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, for industrial applications. Electronically operated, motorized proportional valves make adjustments in 0.1 percent increments. WITT says the system can achieve the desired mixture in less than three seconds, with accuracy better than ±1% absolute.

Seven interface options, among them Ethernet, OPC UA and PROFINET, support integration with existing systems. Users can operate the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface.

The mixer also includes pressure equalization to compensate for supply pressure fluctuations, continuous inlet pressure monitoring and pressure alarms. An integrated buffer tank accommodates fluctuating flow rates. The unit is housed in a splash-proof, brushed stainless steel enclosure and supports maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Regulation and protection

WITT’s dome pressure regulators use optimized pilot pressure regulators intended to maintain stable working pressure despite changes in flow rates and inlet pressures. The company says the design is intended to support consistent process performance and product quality, and that the improvements can be retrofitted to existing WITT dome regulators without replacing the complete system.

The company will also highlight ULTRA non-return valves, which combine low opening pressures, tight sealing and minimal flow resistance to protect gas systems from unwanted backflow. ULTRAVENT safety relief valves are designed to protect against excessive pressure and respond to pressure increases as low as 5 mbar.