SinceVision has introduced the SGI-N030W, a wide-spot laser displacement sensor designed for high-speed, non-contact dimensional measurement on rough, textured and irregular surfaces. The company says the sensor uses an expanded laser spot and optical triangulation, and extends its SGI Series portfolio into lithium-ion battery manufacturing, semiconductor processing and precision mechanical engineering applications that require reliable micrometre-level measurement.
Conventional point-spot laser displacement sensors concentrate reflected energy on a small area. According to SinceVision, this makes readings sensitive to microscopic surface features such as scratches, grain boundaries, brushed textures and matte finishes. Those features can produce signal variations that are interpreted as dimensional changes, potentially creating false defect warnings and additional inspection work.
Wide spot targets surface variation
The SGI-N030W is designed to address this issue by collecting reflected light across a broader surface area. SinceVision says the sensor averages localised microscopic peaks and valleys before signal conversion, reducing the influence of surface roughness and optical scattering. The company identifies drawn metals, sandblasted surfaces and coated battery foils as materials that can benefit from this approach.
Specified performance and interfaces
The sensor has a 30 mm reference distance and a ±5 mm measurement range. SinceVision specifies repeatability of 0.05 µm when measuring a diffuse white target under static conditions, along with linearity of ±0.02% of full scale across the range. A 50 kHz sampling frequency, equivalent to a 20 µs update interval, is intended to support high-speed measurement and monitoring of dynamic processes.
Communication options include RS485, 100Base-TX Ethernet and switchable analogue outputs for 4–20 mA current or 0–10 V voltage signals. The system also supports master-slave synchronisation, allowing two sensors to operate in opposition and measure simultaneously from either side of a component or moving material.
Battery thickness inspection
SinceVision outlines an in-line thickness measurement arrangement for lithium-ion battery electrodes. Coating thickness and uniformity affect energy density, internal resistance and long-term cell stability, but the company says offline inspection with contact micrometers or drop indicators can introduce operator variability and may deform wet or uncured electrode material. Periodic spot measurements also cannot provide continuous coverage across an entire production reel, it adds.
In the proposed setup, two synchronised sensors are positioned above and below a moving electrode web. The opposing heads are mounted on a calibrated, low-thermal-expansion marble gantry and measure their respective clearances to the material. A system controller combines those readings with the fixed mounting datum to calculate absolute electrode thickness in real time.
According to SinceVision, production trials demonstrated stable, repeatable thickness measurement within ±0.3 µm at a web speed of 300 mm/s. The company says the 50 kHz sampling frequency provides high longitudinal resolution for detecting localised coating agglomerations, edge thinning and exposed substrate areas before the electrode proceeds to cell winding.
Other target applications
For semiconductor manufacturing, the sensor is intended for non-contact work involving sensitive wafer surfaces. Potential uses include wafer position verification, edge detection, height measurement and checks of wafer seating and chuck alignment in atmospheric transfer modules and vacuum load-lock systems.
In precision assembly, SinceVision says the sensor can monitor the movement of voice coil motors, linear actuators and micro-steppers. Its sampling rate is intended to capture transient displacement, mechanical oscillations, settling behaviour and end-stop overshoot across the full measurement range. Position data can be sent to machine control systems through the Ethernet interface for real-time monitoring and process control.
Surface errors remain the focus
Jack Li, global sales and marketing director at SinceVision, says false defect warnings caused by surface texture remain a recurring challenge in battery manufacturing and precision assembly. He says conventional point-beam laser sensors can interpret microscopic scratches and rough coatings as actual thickness variations, slowing production lines and creating a need for additional manual inspection.
According to Li, the SGI-N030W’s expanded optical spot is designed to average out these surface-related variations, while synchronisation between opposing sensor heads supports high-speed thickness verification.
