Automotive Accessories

Jeep Builder Turns Humvee Portal Hubs and a Ford 9-Inch Into a Low-Cost Rear Axle

Zeph Gage’s Jeep XJ uses flipped differential geometry and military-derived hubs to add clearance at roughly one-fifth the cost of typical portal axles.

Sofia MarchettiNovember 17, 20265 min read2 views

A cutaway-style view of an off-road SUV’s rear axle on a workshop lift, showing geared portal hubs, a flipped differential housing and custom brake hardware.

Portal axles are prized in hardcore off-roading because they raise the vehicle’s drivetrain components above the wheel centerline, improving ground clearance without relying solely on taller tires. The drawback is cost: a typical set from companies such as 74Weld runs about $20,000. Zeph Gage’s rear-only setup for a Jeep XJ is intended to deliver a similar clearance benefit for roughly one-fifth of that price.

Gage’s build combines a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. It is not an off-the-shelf kit. The installation required custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper.

Flipping the differential to correct direction

Two-gear portal hubs, like the Humvee units, reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential. The arrangement effectively creates a high-pinion unit from low-pinion parts that have simply been turned over.

That change does more than correct the direction of rotation. According to the build details, it adds about six inches of clearance, retains full shock travel and reduces stress on the differential itself. Gage describes the result as effectively bulletproof, a design expectation rather than a confirmed outcome.

Why only the rear axle?

Installing a portal axle only at the rear may seem unusual, but Gage points to a common trick in the remote-control rock-crawler scene. Keeping a solid axle up front avoids the packaging constraints that can arise when adding portal axles to a vehicle that never had them from the factory. It also avoids restricting shock travel to fit the front conversion and keeps the ride height from rising excessively.

The resulting Jeep XJ can drive over a five-gallon bucket and still have several inches of spare clearance, according to the article. That means the rear end is less likely to hang up on obstacles that the front end can steer around. Gage matched the gearing front and rear, and he detailed the build in a video from Outdoor Auto.

The project shows how military-derived parts and careful rethinking of differential orientation can lower the cost of portal-axle performance. It also highlights the trade-offs: the setup depends on custom fabrication and a rear-only layout rather than a complete, factory-style portal conversion.